INSTALLATION INSTRUCTIONS
(Professional installation recommended)
Take proper care not to damage the spoiler during handling and installation. 1. Clean and prepare trunk lid. |
||
2. Insert Locator strips provided in hardware kit into mounting holes. |
 |
|
| 3. Position the spoiler and find the most suitable location on the trunk lid. Be sure to measure and verify that the spoiler is symmetrical from all angles. |
 |
|
| 4. Tape down the Locator strips. |  |
|
| 5. Carefully remove the spoiler leaving
the locator strips taped to the trunk in position. |
 |
|
| 6. Use a 1/8" drill bit to drill a pilot hole through the locator strips. If spoiler is equipped with a brake light, locate and drill a hole for the wire. |
 |
|
| 7. Remove the hole locators and open up the holes using a 3/8" drill bit. |
||
| 8. Treat all bare steel with rust proof paint. | ||
| 9. If spoiler requires brake light, feed the brake light wire through the channel and install the brake light using the screws provided for the light. | ||
| 10. Screw the spoiler in place using the screws provided. Tighten the screws by hand. Avoid over-tightening. CAUTION: Never use power tools to tighten fixing screws as this voids all warranty. | ||
| 11. If applicable hook up the brake light wire to the third brake light. | ||
Be sure to remove all metal shavings and clean the trunk lid thoroughly! CAUTION: Never use the spoiler as a handle to open or close the trunk lid. | ||